1 Extended commands are available using the period ( . ) key. To use
2 a dot command, press the . key, and then enter the first letter of
3 each word in the command. The words will appear as you enter the keys.
4 You can also backspace over partially entered commands. The following
5 commands are available:
7 .<E>nter message using <A>scii - raw mode message input
8 .<E>nter <B>io - tell everyone about yourself
9 .<E>nter <C>onfiguration - set up your account statistics
10 .<E>nter message with <E>ditor - (installation dependent)
11 .<E>nter re<G>istration - enter your name, address, etc.
12 .<E>nter <M>essage - enter message with the Citadel editor
13 .<E>nter <P>assword - change your password
14 .<E>nter <R>oom - create a new room
15 .<E>nter <T>extfile - ASCII upload
16 .<E>nter file using <X>modem - protocol upload
17 .<E>nter file using <Y>modem - protocol upload
18 .<E>nter file using <Z>modem - protocol upload
20 .<R>ead <B>io - read other users' bios
21 .<R>ead <D>irectory - directory of current room
22 .<R>ead <F>ile unformatted - raw ASCII download
23 .<R>ead <I>nfo file - read info file for this room
24 .<R>ead <L>ast five messages - same as <L>
25 .<R>ead <N>ew messages - same as <N>
26 .<R>ead <O>ld messages - same as <O>
27 .<R>ead <R>everse - same as <R>
28 .<R>ead <T>extfile paginated - prints a textfile with page prompts
29 .<R>ead <U>ser List - lists users with accounts on system
30 .<R>ead file using <X>modem - protocol download
31 .<R>ead file using <Y>modem - protocol download
32 .<R>ead file using <Z>modem - protocol download
34 .<G>oto room: (type roomname) - jump to a specific room
35 (you only need to type enough of the
36 room name to make it unique)
37 .<S>kip, goto: (type roomname) - skip current room, jump to another
38 .<H>elp file: (type filename) - read a help file
39 .<T>erminate and <Q>uit - log out immediately without prompts
40 .<T>erminate and <S>tay online - log out and allow another user to log in
41 .<Z>apped room list - list all zapped (forgotten) rooms
43 Floor commands (if using floor mode)
44 ;<C>onfigure floor mode - turn floor mode on or off
45 ;<G>oto floor: - jump to a specific floor
46 ;<K>nown rooms - list all rooms on all floors
47 ;<S>kip to floor: - skip current floor, jump to another
48 ;<Z>ap floor - zap (forget) all rooms on this floor